Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER (except TMC Made GR SPORT) › from 2020.12
RM32K0E _59 Vehicle Exterior _061792 EXTERIOR PANELS / TRIM _0455086 FRONT BUMPER(except TMC Made GR SPORT) A

EXTERIOR PANELS / TRIM  FRONT BUMPER(except TMC Made GR SPORT)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT BUMPER ASSEMBLY

a.

Move the front bumper assembly into position.


b.
B557765E02
0.833,1.313 0.958,1.5 0.125,0.188 10 true B 1.01,0.219 1.146,0.385 0.135,0.167 10 true A

w/ Toyota Safety Sense:

i.

Connect the connector A.



c.

w/ Wire Harness:

i.

Connect the connector B.



d.

w/ Headlight Cleaner System:

i.

Connect the washer hose.



e.
B557761C01
0,0 0,0 false
V113147

Install in this Direction


Temporarily install the front bumper assembly with the engage claw as shown in the illustration.


f.

Install the 3 bolts.


g.
B557762C01
0,0 0,0 false
V113147

Install in this Direction


Engage the claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



h.

Install the 6 screws.


i.
B474011C01
1.854,1.917 2.167,2.073 0.313,0.156 10 false *a 2.833,1.917 3.146,2.073 0.313,0.156 10 false *b
*a Correct
*b Incorrect


Install the pin hold clip as shown in the illustration.

NOTICE:

Insert the pin hold clip with the slot aligned vertically.

Do not rotate the clip after inserting it.

After installation, confirm that the slot is aligned vertically.


HINT:

Use the same procedure for the RH side and LH side.



j.

Remove the protective tape.


Hide 75602A 2.INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH

a.
B557782C01
0,0 0,0 false
V113147

Install in this Direction


Engage the clips and claws to install the front fender moulding sub-assembly LH as shown in the illustration.


b.

Install the 3 screws.


c.

Install the 2 clips.


d.

Remove the protective tape.


Hide 75601A 3.INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 53141F 4.INSTALL RADIATOR COVER

a.
B557763

Engage the guides and claws to install the radiator cover as shown in the illustration.


b.

for 2ZR-FXE:

i.

Install the 5 clips.



c.

for M20A-FXS:

i.

Install the 4 clips.



d.

Install the 2 hood bumper cushions.


Hide 5.ADJUST FOG LIGHT ASSEMBLY (w/ Fog Light)

Hide 6.ADD WINDSHIELD WASHER FLUID (w/ Headlight Cleaner System)

Hide 7.PERFORM CALIBRATION

·

Parking support brake system and Simple intelligent parking assist system:

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING SUPPORT BRAKE SYSTEM>CALIBRATION