Wear protective gloves. Sharp areas on the parts may injure your hands.
Power seat is available only on the driver side.
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
72108
1.INSTALL UPPER SEAT TRACK RAIL SUB-ASSEMBLY LH
Make sure to read the warnings printed on the box of the upper seat track rail sub-assembly LH before performing operations.
| *a | 80 mm (3.15 in.) |
In order to reduce the risk of damage to the part and to ensure ease of operations, secure a space of 80 mm (3.15 in.) or more as shown in the illustration.
Secure enough space to ensure that the upper seat track rail sub-assembly LH does not contact any other objects during installation.
Install a new upper seat track rail sub-assembly LH with the 8 nuts.
Engage the clamp.
|
Install in this direction |
Engage the clamp and claw to install the front seat lower No. 1 cushion shield LH as shown in the illustration.
|
Install in this direction |
Engage the guide and claw to install the front seat lower cushion shield LH as shown in the illustration.
| *a | Clamp |
| *b | Guide |
|
Install in this direction |
Engage the guide and claw to install the front seat lower cushion shield RH as shown in the illustration.
Engage the clamp.
|
Install in this direction |
Engage the guide and 2 claws as shown in the illustration.
Install the 2 screws to install the front seat cushion wire harness holder LH.
Engage the claw and 2 clamps.
Connect the slide motor connector.
71812D
2.INSTALL FRONT SEAT CUSHION SHIELD LH
71868A
3.INSTALL FRONT SEAT INNER NO. 1 CUSHION SHIELD LH
4.INSTALL FRONT SEAT ASSEMBLY LH