Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for eCall with Dual Knob Type Radio and Display) › from 2022.01
RM32K0E _56 Audio / Visual / Telematics _084041 TELEMATICS _0524446 TELEMATICS SYSTEM(for eCall with Dual Knob Type Radio and Display) C

TELEMATICS  TELEMATICS SYSTEM(for eCall with Dual Knob Type Radio and Display)  B15C5  Emergency Switch Error (Open or Short)  


DESCRIPTION

This DTC is stored when the telematics transceiver detects an open or short circuit in the manual (SOS) switch.

DTC No. Detection Item DTC Detection Condition Trouble Area
B15C5 Emergency Switch Error (Open or Short) Open or short circuit in the manual (SOS) switch is detected
·

Telematics transceiver

·

Map light assembly (manual (SOS) switch)

·

Harness or connector



WIRING DIAGRAM

E354792E30
0.927,2.042 1.385,2.24 0.458,0.198 10 false R15 0.927,2.229 2.958,2.635 2.031,0.406 10 false Map Light Assembly 4.667,1.927 5.656,2.125 0.99,0.198 10 false F165 4.656,2.115 6.948,2.448 2.292,0.333 10 false Telematics Transceiver 2.563,0.604 3.177,0.802 0.615,0.198 10 false SIG1 5.156,0.646 5.771,0.844 0.615,0.198 10 false SIG1 2.479,1.177 3.094,1.375 0.615,0.198 10 false GND3 5.156,1.156 5.771,1.354 0.615,0.198 10 false SIG- 2.948,0.583 3.125,0.781 0.177,0.198 10 false 8 2.948,1.167 3.167,1.396 0.219,0.229 10 false 1 4.927,0.625 5.24,0.823 0.313,0.198 10 false 27 4.906,1.177 5.219,1.375 0.313,0.198 10 false 26 1.031,1.667 3.063,2.073 2.031,0.406 10 false Manual (SOS) Switch

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for eCall with Dual Knob Type Radio and Display)>REGISTRATION

·

When replacing the telematics transceiver, make sure to replace it with a new one.



PROCEDURE

1.CHECK DTC
a.

Turn the power switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG) and wait for 10 seconds.


d.

Turn the GTS on.


e.

f.

Check for DTCs and check that no DTCs are output.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for eCall with Dual Knob Type Radio and Display)>DTC CHECK / CLEAR

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

2.INSPECT MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH)
2.INSPECT MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH)
a.

Remove the map light assembly (manual (SOS) switch).

Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT (for TMMT Made)>REMOVAL


b.
B129570C93
2.844,1.74 2.615,1.104 true 0.938,1.813 1.24,1.104 true 0.115,0.094 0.385,0.313 0.271,0.219 10 false *a 2.719,1.781 3.229,2.063 0.51,0.281 10 false GND3 0.75,1.875 1.167,2.083 0.417,0.208 10 false SIG1
*a Component without harness connected
(Map Light Assembly (Manual (SOS) Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
R15-8 (SIG1) - R15-1 (GND3) Manual (SOS) switch not pressed 392 to 432 Ω
R15-8 (SIG1) - R15-1 (GND3) Manual (SOS) switch pressed 78 to 86 Ω



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH))

NG

REPLACE MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH)

3.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH))
a.

Disconnect the F165 telematics transceiver connector.


b.

Disconnect the R15 map light assembly (manual (SOS) switch) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F165-27 (SIG1) - R15-8 (SIG1) Always Below 1 Ω
F165-26 (SIG-) - R15-1 (GND3) Always Below 1 Ω
F165-27 (SIG1) or R15-8 (SIG1) - Body ground Always 10 kΩ or higher
F165-26 (SIG-) or R15-1 (GND3) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY
a.

Replace the telematics transceiver with a new one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL


Result:
Proceed to
NEXT



NEXT