Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for eCall with Single Knob Type Radio and Display) › from 2022.01
RM32K0E _56 Audio / Visual / Telematics _084041 TELEMATICS _0524469 TELEMATICS SYSTEM(for eCall with Single Knob Type Radio and Display) D

TELEMATICS  TELEMATICS SYSTEM(for eCall with Single Knob Type Radio and Display)  VEHICLE CONTROL HISTORY  


NOTICE:

Make sure to record any output Vehicle Control History codes before clearing them and checking the Vehicle Control History again.


CHECK VEHICLE CONTROL HISTORY


a.

Using the GTS to perform the "Vehicle Control History (RoB)".

Body Electrical > Telematics > Utility
Tester Display
Vehicle Control History (RoB)
50005 459 55
Vehicle Control History Item
Code Tester Display Description Diagnostic Note
X2210 Life Cycle of DCM Backup Battery When the system detects that the mobilephone battery has reached the end of its lifespan.
·

The mayday switch assembly red indicator blinks

·

Replace mobilephone battery

(Click here)


NOTICE:
·

After replacing the mobilephone battery, perform initialization.

(Click here)

·

After performing work, perform "CLEAR VEHICLE CONTROL HISTORY" to turn off the mayday switch assembly red indicator.



X2211 Low DCM Backup Battery Charge When the mobile phone battery charge is low. -
X2601 Software Inconsistency with ENG/HV Control Module The VIN number received via CAN communication does not match that stored in the DCM.
·

The mayday switch assembly red indicator blinks

·

Perform VIN Synchronization

(Click here)


X2212 Diagnostics Communication Flow Failure Diagnostics communication flow failure (ID, Mode/SID difference). -
X2213 Mayday Switch Assembly Stuck On The mayday switch assembly is on for 5 minutes or more Replace map light sub-assembly
(Click here)
X2214 Communication Blackout from Power Distribution Controller ECU Lost Communication with ECM. Check CAN Communication System
(Click here)
X2215 Non Approval of the Reprograming User did not approve software update. -
X2216 Failure of the Reprogramming Software writing failed. -
X2217 Inconsistent Startup Software Software writing succeeded, but started software does not match package. -
X2218 Communication Blackout from Body Controller ECU Lost communication with main body ECU (multiplex network body ECU) Check CAN Communication System
(Click here)
X21D4 Reprograming Telematics ECU by OTA Start/Finish At the time of a start of the software update of DCM by the OTA, I memorize it at the time of success. -



CLEAR VEHICLE CONTROL HISTORY


NOTICE:

By performing this procedure, all stored Vehicle Control History will be cleared.


a.

Using the GTS to perform the "Vehicle Control History (RoB)" (Clear).

Body Electrical > Telematics > Utility
Tester Display
Vehicle Control History (RoB)
50005 459 55

b.

According to the display on the GTS, clear the Vehicle Control History (RoB).