Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type with Dual Knob Type) › from 2022.01
RM32K0E _56 Audio / Visual / Telematics _061290 NAVIGATION / MULTI INFO DISPLAY _0524476 NAVIGATION SYSTEM(for Radio and Display Type with Dual Knob Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type with Dual Knob Type)  Parking Brake Switch Circuit  


DESCRIPTION

This circuit is from the parking brake ECU (brake actuator assembly) to the radio and display receiver assembly.

WIRING DIAGRAM

E360334E11
5,2.135 6.74,2.531 1.74,0.396 10 false Radio and Display Receiver Assembly 5.396,1.125 6.542,1.323 1.146,0.198 10 false PKB 2.5,0.885 3.646,1.083 1.146,0.198 10 false MGND 2.5,1.313 3.646,1.51 1.146,0.198 10 false EGND 5,1.979 5.615,2.177 0.615,0.198 10 false F131 2.438,1.656 4.313,1.865 1.875,0.208 10 false A84*1 A85*2 2.417,1.833 4.063,2.281 1.646,0.448 10 false Parking Brake ECU (Brake Actuator Assembly) 3.698,1.104 4.844,1.302 1.146,0.198 10 false PKB 5.115,0.99 5.542,1.177 0.427,0.188 10 false 20 4.094,0.969 4.521,1.156 0.427,0.188 10 false 19 2.313,1.188 2.792,1.396 0.479,0.208 10 false 2 2.313,0.771 2.792,0.979 0.479,0.208 10 false 1 0.229,2.417 1.917,2.615 1.688,0.198 10 false *1: for RHD 1.135,2.417 2.823,2.615 1.688,0.198 10 false *2: for LHD

PROCEDURE

1.CHECK ELECTRIC PARKING BRAKE SYSTEM
a.

Check the operation of the electric parking brake.

Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR>ON-VEHICLE INSPECTION


Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (PARKING BRAKE ECU (BRAKE ACTUATOR ASSEMBLY) - RADIO AND DISPLAY RECEIVER ASSEMBLY)

NG

2.CHECK HARNESS AND CONNECTOR (PARKING BRAKE ECU (BRAKE ACTUATOR ASSEMBLY) - RADIO AND DISPLAY RECEIVER ASSEMBLY)
a.

Disconnect the F131 radio and display receiver assembly connector.


b.

Disconnect the A84*1 or A85*2 parking brake ECU (brake actuator assembly) connector.

*1: for RHD

*2: for LHD



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
for RHD
Tester Connection Condition Specified Condition
F131-20 (PKB) - A84-19 (PKB) Always Below 1 Ω
F131-20 (PKB) - Body ground Always 10 kΩ or higher

for LHD
Tester Connection Condition Specified Condition
F131-20 (PKB) - A85-19 (PKB) Always Below 1 Ω
F131-20 (PKB) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR