Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR (for AWD) › 2016.10–2019.09
RM32H0E _53 Suspension _059601 REAR SUSPENSION _0292272 REAR STABILIZER BAR(for AWD) A

REAR SUSPENSION  REAR STABILIZER BAR(for AWD)  INSTALLATION  


PROCEDURE

Hide 48818 1.INSTALL REAR STABILIZER BUSHING

a.

Install the 2 rear stabilizer bushings to the rear stabilizer bar.

NOTICE:

Be sure to install the rear stabilizer bushings so that each cutout faces the front of the vehicle.



Hide 48832A 2.INSTALL REAR NO. 1 STABILIZER BAR BRACKET

a.
C365594C01
0.688,1.469 1.188,1.104 true 1.219,0.948 1.531,1.146 0.313,0.198 10 false *a
*a Arrow Mark
V100135

Upper of the Vehicle


Install the 2 rear No. 1 stabilizer bar brackets to the 2 rear stabilizer bushings.

NOTICE:

Be sure to install the rear No. 1 stabilizer bar brackets so that each arrow mark faces the front of the vehicle.



Hide 48812 3.INSTALL REAR STABILIZER BAR

a.
C365595C01
0.302,1.271 0.479,1.781 true 0.458,0.542 0.615,0.74 0.156,0.198 10 true A 0.51,1.385 0.667,1.583 0.156,0.198 10 true B 2.781,1.344 2.938,1.542 0.156,0.198 10 true B 2.833,0.583 2.99,0.781 0.156,0.198 10 true A 0.438,1.823 0.594,2.021 0.156,0.198 10 true *a
*a Identification Mark


Install the rear stabilizer bar, 2 rear No. 1 stabilizer bar brackets and 2 rear stabilizer bushings to the rear suspension member sub-assembly with the 4 bolts.

Torque:
78 N*m (795 kgf*cm, 58 ft.*lbf)

NOTICE:
·

Ensure that the identification mark faces the right side of the vehicle.

·

Temporarily tighten bolt (A) and then fully tighten the 2 bolts in the order of (B) and (A).




Hide 48840A 5.INSTALL REAR STABILIZER LINK ASSEMBLY LH

a.
C365342N01
1.583,1.427 1.74,1.625 0.156,0.198 10 true A 1.146,4.24 1.302,4.438 0.156,0.198 10 true B

Install the rear stabilizer link assembly LH with the nut (A).

Torque:
75 N*m (765 kgf*cm, 55 ft.*lbf)

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.



b.

Install the rear stabilizer link assembly LH with the bolt and nut (B).

Torque:
75 N*m (765 kgf*cm, 55 ft.*lbf)

NOTICE:

When installing the nut, keep the bolt from rotating.



Hide 48830D 6.INSTALL REAR STABILIZER LINK ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 7.INSTALL REAR WHEEL