Home › Steering › STEERING COLUMN › STEERING PAD SWITCH › 2016.10–2019.09
RM32H0E _55 Steering _059604 STEERING COLUMN _0292298 STEERING PAD SWITCH A

STEERING COLUMN  STEERING PAD SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering pad switch assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point
·

Lane departure alert system (w/ Steering Control)

·

Simple intelligent parking assist system*1

·

Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1

·

Pre-collision system


(Click here)
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system (Click here)


PROCEDURE

Hide 45130 1.REMOVE HORN BUTTON ASSEMBLY

Hide 84250A 2.REMOVE STEERING PAD SWITCH ASSEMBLY

a.
C365796

Disconnect connector from the spiral cable with sensor sub-assembly.


b.
C365797

Remove the 2 screws.


c.

Disengage the 4 claws and 4 pins to remove the steering pad switch assembly.