Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING ECU(for RHD) › 2016.10–2019.09
RM32H0E _55 Steering _059605 POWER ASSIST SYSTEMS _0292303 POWER STEERING ECU(for RHD) A

POWER ASSIST SYSTEMS  POWER STEERING ECU(for RHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the power steering ECU assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point
·

Lane departure alert system (w/ Steering Control)

·

Simple intelligent parking assist system*1

·

Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1

·

Pre-collision system


(Click here)
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system (Click here)
Power steering ECU assembly
·

Torque sensor zero point calibration

·

Assist map writing


·

DTCs are stored

·

EPS warning light illuminates


(Click here)


PROCEDURE

Hide 1.REMOVE STEERING COLUMN ASSEMBLY

Hide 89650 2.REMOVE POWER STEERING ECU ASSEMBLY

NOTICE:
·

Do not drop the power steering ECU assembly, strike it with tools or subject it to impacts.

·

If the power steering ECU assembly is subjected to an impact, replace it with a new one.

·

Do not pull the wire harness of the electric power steering column sub-assembly.

·

Do not allow any moisture to come into contact with the power steering ECU assembly.

·

Do not loosen any bolts not mentioned in the procedure.

·

Do not allow any foreign matter to contaminate the power steering ECU assembly.



a.
C366718

Disconnect the connector.


b.

for Type A:

i.
C365311

Using a T40 "TORX" socket wrench, remove the 2 screws and power steering ECU assembly from the electric power steering column sub-assembly.



c.
C345187

for Type B:

i.

Remove the 2 bolts and power steering ECU assembly from the electric power steering column sub-assembly.



Hide 45254B 3.REMOVE ELECTRIC POWER STEERING MOTOR SHAFT DAMPER

a.
C345188

Remove the electric power steering motor shaft damper from the electric power steering column sub-assembly.