Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER
RM32H0E _53 Suspension _059606 TIRE PRESSURE MONITORING _0292311 TIRE PRESSURE WARNING RECEIVER A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RECEIVER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during tire pressure warning ECU and receiver removal/installation are shown below.

Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Tire pressure warning ECU and receiver (Electrical key and tire pressure monitoring system receiver assembly)
·

Register transmitter ID

·

Initialize tire pressure warning system


·

When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

·

Tire pressure warning function


(Click here)for Registration
(Click here)for Initialization

NOTICE:

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST


PROCEDURE

Hide 64740C 1.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 897B0 2.REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER

NOTICE:
·

Do not drop, strike or otherwise subject the tire pressure warning ECU and receiver to impact.

·

If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.



a.
B450706

Remove the bolt.


b.

Disengage the 2 guides.


c.

Disconnect the connector to remove the tire pressure warning ECU and receiver.