Home › Drivetrain › K114 (MULTIDRIVE / CVT) › OIL PRESSURE SENSOR
RM32H0E _52 Drivetrain _059616 K114 MULTIDRIVE / CVT _0292456 OIL PRESSURE SENSOR A

K114 MULTIDRIVE / CVT  OIL PRESSURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the oil pressure sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of oil pressure sensor Perform the following procedures in the order shown:
1.

Reset memory

2.

Deceleration sensor zero point calibration

3.

CVT oil pressure calibration


Deterioration of fuel efficiency (Click here)

PROCEDURE

Hide 1.REMOVE FRONT WHEEL LH

Hide 51441 2.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51444A 3.REMOVE REAR ENGINE UNDER COVER LH

Hide 89637K 4.REMOVE OIL PRESSURE SENSOR

C296018

a.

Disconnect the oil pressure sensor connector.


b.
C328303N01
1.531,0.688 1.531,0.313 1.531,0.313 1.885,0.313 true 1.948,0.219 2.406,0.417 0.458,0.198 10 true SST

Using SST, remove the oil pressure sensor from the continuously variable transaxle assembly.

SST
09326-22011