Home › Drivetrain › K114 (MULTIDRIVE / CVT) › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM
RM32H0E _52 Drivetrain _059616 K114 MULTIDRIVE / CVT _0292534 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM C

K114 MULTIDRIVE / CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  P1750  Brake ECU Malfunction  


DESCRIPTION

When the ECM receives a malfunction signal from the skid control ECU (brake actuator assembly), DTC P1750 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P1750 Brake ECU Malfunction The ECM receives a malfunction signal from the skid control ECU (brake actuator assembly) for 3 seconds (1 trip detection logic). Vehicle stability control system Comes on DTC stored

CAUTION / NOTICE / HINT

HINT:

After performing repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

1.

Drive the vehicle at 20 km/h (12 mph) or more for 9 seconds or more.



PROCEDURE

1.CHECK DTC OUTPUT (BRAKE CONTROL SYSTEM)
a.

Check for brake control system DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

B