Home › Drivetrain › AXLE AND DIFFERENTIAL › DIFFERENTIAL MOUNT CUSHION
RM32H0E _52 Drivetrain _059517 AXLE AND DIFFERENTIAL _0292804 DIFFERENTIAL MOUNT CUSHION A

AXLE AND DIFFERENTIAL  DIFFERENTIAL MOUNT CUSHION  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear No. 1 differential mount cushion removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear wheel alignment adjustment
1.

Clear zero point calibration data.

2.

Perform yaw rate and acceleration sensor zero point calibration.


·

DTCs are stored

·

ABS warning light illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)
·

Rear height control sensor sub-assembly LH*1

·

Suspension, tires, etc.

(The vehicle height changes because of suspension or tire replacement)


Initialize No. 1 headlight ECU sub-assembly LH Automatic headlight beam level control system (Click here)

*1: w/ Height Control Sensor


PROCEDURE

Hide 41110 1.REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY

Hide 41651 2.REMOVE REAR NO. 1 DIFFERENTIAL MOUNT CUSHION

a.

Using SST, remove the rear No. 1 differential mount cushion.

SST
09316-12010  09570-24011  

C360073C01
6.021,0.625 6.354,0.625 false 6.167,2.5 5.833,1.594 true 6.167,2.5 6.229,1.479 true 6.167,2.5 6.323,1.448 true 6.385,0.521 6.698,0.677 0.313,0.156 10 false *1 5,2.75 5.313,2.906 0.313,0.156 10 false *a 3.51,2.823 3.823,2.979 0.313,0.156 10 false *b 6.031,2.542 6.344,2.729 0.313,0.188 10 false SST
*1 Rear Suspension Member Sub-assembly - -
*a Turn *b Hold
V100135

Turning Direction
V100136

Front of Vehicle
V100137

SST Bolt Position - -


NOTICE:
·

Do not bring SST into contact with the rear suspension member sub-assembly.

·

Before using SST, apply grease to SST bolt.

·

Set SST in the correct direction.

·

Do not tilt the bolt of SST.

·

Do not reuse the rear No. 1 differential mount cushion.