Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL CARRIER ASSEMBLY
RM32H0E _52 Drivetrain _059517 AXLE AND DIFFERENTIAL _0292803 REAR DIFFERENTIAL CARRIER ASSEMBLY A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL CARRIER ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear differential carrier assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear wheel alignment adjustment
1.

Clear zero point calibration data.

2.

Perform yaw rate and acceleration sensor zero point calibration.


·

DTCs are stored

·

ABS warning light illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)
·

Rear height control sensor sub-assembly LH*1

·

Suspension, tires, etc.

(The vehicle height changes because of suspension or tire replacement)


Initialize No. 1 headlight ECU sub-assembly LH Automatic headlight beam level control system (Click here)

*1: w/ Height Control Sensor


PROCEDURE

Hide 1.DRAIN DIFFERENTIAL OIL

Hide 2.REMOVE REAR WHEEL

Hide 37100 3.REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

Hide 77642A 4.REMOVE NO. 2 FUEL TANK PROTECTOR

Hide 77606 5.REMOVE NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY

Hide 42330 8.REMOVE REAR DRIVE SHAFT ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 58327B 9.REMOVE MAIN MUFFLER HEAT INSULATOR

a.
C363402

Remove the 4 nuts and main muffler heat insulator from the vehicle body.


Hide 41110 10.REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY

a.
C360069C01
0,0 0,0 false

Disengage the 2 wire harness clamps to separate the wire harness.


b.

Disconnect the connector.


c.

Remove the bolt and wire harness clamp bracket.


d.

Remove the breather tube.


e.

Support the rear differential carrier assembly with a transmission jack.

C368155N02
1.479,2.083 1.635,2.281 0.156,0.198 10 true A 4.396,1.594 4.552,1.792 0.156,0.198 10 true A 6.271,2.531 6.427,2.729 0.156,0.198 10 true B


f.

Remove the 2 bolts labeled A and bolt labeled B.


g.

Slowly lower the jack and then tilt the rear differential carrier assembly.


Hide 11.REMOVE REAR NO. 1 DIFFERENTIAL SUPPORT

a.
C368143

Remove the 2 bolts and rear No. 1 differential support from the rear differential carrier assembly.


Hide 12.REMOVE REAR NO. 2 DIFFERENTIAL SUPPORT

a.
C368144

Remove the 2 bolts and rear No. 2 differential support from the rear differential carrier assembly.


Hide 52391A 13.REMOVE REAR DIFFERENTIAL SUPPORT

a.
C127579

Remove the 4 bolts and rear differential support from the rear differential carrier assembly.