Home › Drivetrain › AXLE AND DIFFERENTIAL › DIFFERENTIAL MOUNT CUSHION
RM32H0E _52 Drivetrain _059517 AXLE AND DIFFERENTIAL _0292804 DIFFERENTIAL MOUNT CUSHION A

AXLE AND DIFFERENTIAL  DIFFERENTIAL MOUNT CUSHION  INSTALLATION  


PROCEDURE

Hide 41651 1.INSTALL REAR NO. 1 DIFFERENTIAL MOUNT CUSHION

a.

Using SST, install a new rear No. 1 differential mount cushion.

SST
09316-12010  09570-24011  

C360074C01
5.906,0.625 6.5,0.583 false 6.083,1.594 6.417,1.75 true 5.781,1.479 5.667,1.833 true 5.667,1.833 5.698,1.438 true 6.521,0.469 6.833,0.625 0.313,0.156 10 false *1 6.021,2.115 6.333,2.271 0.313,0.156 10 false *a 5.74,0.271 5.948,0.427 0.208,0.156 10 true *b 3.104,2.5 3.417,2.656 0.313,0.156 10 false *c 4.583,2.385 4.896,2.542 0.313,0.156 10 false *d 6.458,1.667 6.781,1.854 0.323,0.188 10 false SST 5.5,1.844 5.823,2.031 0.323,0.188 10 false SST
*1 Rear Suspension Member Sub-assembly - -
*a -3° to 3° *b 5.0 to 6.0 mm (0.197 to 0.236 in.)
*c Turn *d Hold
V100135

Turning Direction
V100136

Front of Vehicle
V100137

SST Bolt Position - -


NOTICE:
·

Make sure that the differential mount cushion is aligned within 3° from the center.

·

Be sure to use the correct combination of SST.

·

Before using SST, apply grease to SST bolt.

·

Temporarily install the rear No. 1 differential mount cushion to the rear suspension member sub-assembly in order to prevent it from tilting, and then install SST.

·

Make sure that SST contacts the entire circumference of the rear No. 1 differential mount cushion.

·

Do not tilt the bolts of SST.




Hide 41110 2.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY