Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL CARRIER ASSEMBLY
RM32H0E _52 Drivetrain _059517 AXLE AND DIFFERENTIAL _0292803 REAR DIFFERENTIAL CARRIER ASSEMBLY A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL CARRIER ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 52391A 1.INSTALL REAR DIFFERENTIAL SUPPORT

a.

Install the rear differential support to the rear differential carrier assembly with 4 new bolts.

Torque:
72 N*m (734 kgf*cm, 53 ft.*lbf)


Hide 2.INSTALL REAR NO. 1 DIFFERENTIAL SUPPORT

a.

Install the rear No. 1 differential support to the rear differential carrier assembly with 2 new bolts.

Torque:
55 N*m (561 kgf*cm, 41 ft.*lbf)


Hide 3.INSTALL REAR NO. 2 DIFFERENTIAL SUPPORT

a.

Install the rear No. 2 differential support to the rear differential carrier assembly with 2 new bolts.

Torque:
55 N*m (561 kgf*cm, 41 ft.*lbf)


Hide 41110 4.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

a.

Support the rear differential carrier assembly with a transmission jack or equivalent.


b.

Slowly raise the transmission jack, and install 3 new bolts.

C368155N02
1.479,2.083 1.635,2.281 0.156,0.198 10 true A 4.396,1.594 4.552,1.792 0.156,0.198 10 true A 6.271,2.531 6.427,2.729 0.156,0.198 10 true B

Torque:
for bolt A : 86 N*m (877 kgf*cm, 63 ft.*lbf)
for bolt B : 106 N*m (1080 kgf*cm, 78 ft.*lbf)


c.

Install the breather tube.


d.

Install the wire harness clamp bracket with the bolt.

Torque:
19.6 N*m (200 kgf*cm, 14 ft.*lbf)


e.

Connect the connector.


f.

Connect the 2 harness clamps.


Hide 5.INSTALL MAIN MUFFLER HEAT INSULATOR

a.

Install the main muffler heat insulator to the vehicle body with the 4 nuts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 42330 7.INSTALL REAR DRIVE SHAFT ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 77606 9.INSTALL NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY

Hide 77642A 10.INSTALL NO. 2 FUEL TANK PROTECTOR

Hide 37100 11.INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

Hide 12.ADD DIFFERENTIAL OIL

Hide 13.INSTALL REAR WHEEL