Home › Engine / Hybrid System › 3ZR-FAE (INTAKE / EXHAUST) › EXHAUST PIPE
RM32H0E _51 Engine / Hybrid System _059727 3ZR-FAE INTAKE / EXHAUST _0292824 EXHAUST PIPE A

3ZR-FAE INTAKE / EXHAUST  EXHAUST PIPE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front exhaust pipe assembly (TWC: Front and Rear Catalyst) and tail exhaust pipe assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Gas leak from exhaust system is repaired Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
A344784

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


PROCEDURE

Hide 57533B 1.REMOVE FRONT FLOOR CENTER BRACE

Hide 17430 2.REMOVE TAIL EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A393392

Remove the 2 bolts and 2 compression springs and disconnect the tail exhaust pipe assembly from the front exhaust pipe assembly (TWC: Front and Rear Catalyst).


b.

Remove the tail exhaust pipe assembly from the 4 exhaust pipe supports.


c.

Remove the exhaust pipe gasket from the front exhaust pipe assembly (TWC: Front and Rear Catalyst).


Hide 17410 3.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Front and Rear Catalyst)

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A393518

Disconnect the heated oxygen sensor connector.


b.

Disengage the wire harness clamp.


c.
A393393

Remove the 2 bolts and 2 compression springs and disconnect the front exhaust pipe assembly (TWC: Front and Rear Catalyst) from the exhaust manifold.


d.

Remove the front exhaust pipe assembly (TWC: Front and Rear Catalyst) from the 2 exhaust pipe supports.


e.

Remove the exhaust pipe gasket from the exhaust manifold.