Home › Engine / Hybrid System › 3ZR-FAE (INTAKE / EXHAUST) › EXHAUST MANIFOLD
RM32H0E _51 Engine / Hybrid System _059727 3ZR-FAE INTAKE / EXHAUST _0292823 EXHAUST MANIFOLD A

3ZR-FAE INTAKE / EXHAUST  EXHAUST MANIFOLD  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during exhaust manifold removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of air fuel ratio sensor

·

Gas leak from exhaust system is repaired


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
·
A344783

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.

·
A344784

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.



PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 57533B 2.REMOVE FRONT FLOOR CENTER BRACE

a.
A393191

Remove the 12 bolts and 3 front floor center braces from the vehicle body.


Hide 17410 3.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Front and Rear Catalyst)

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A393518

Disconnect the heated oxygen sensor connector.


b.

Disengage the wire harness clamp.


c.
A393208

Remove the 4 bolts and 4 compression springs and disconnect the front exhaust pipe assembly (TWC: Front and Rear Catalyst) from the exhaust manifold and tail exhaust pipe assembly.


d.

Remove the front exhaust pipe assembly (TWC: Front and Rear Catalyst) from the 2 exhaust pipe supports.


e.

Remove the 2 exhaust pipe gaskets from the exhaust manifold and front exhaust pipe assembly (TWC: Front and Rear Catalyst).


Hide 17167 5.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A393209

Disengage the 3 clamps.


b.

Remove the bolt and wire harness clamp bracket from the cylinder head sub-assembly.


c.
A393210

Remove the 4 bolts and No. 1 exhaust manifold heat insulator from the exhaust manifold.


Hide 17118 6.REMOVE MANIFOLD STAY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A393211

Remove the 3 bolts and manifold stay from the exhaust manifold, drive shaft bearing case sub-assembly and cylinder block sub-assembly.


Hide 17141 7.REMOVE EXHAUST MANIFOLD

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A393212

Remove the 5 nuts and exhaust manifold from the cylinder head sub-assembly.


b.

Remove the exhaust manifold to head gasket from the cylinder head sub-assembly.


Hide 17168 8.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A393213

Remove the 4 bolts and No. 2 exhaust manifold heat insulator from the exhaust manifold.