Home › Engine / Hybrid System › 3ZR-FAE (ENGINE CONTROL) › THROTTLE BODY
RM32H0E _51 Engine / Hybrid System _059607 3ZR-FAE ENGINE CONTROL _0293871 THROTTLE BODY A

3ZR-FAE ENGINE CONTROL  THROTTLE BODY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the throttle body assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of throttle body assembly Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Cleaning the deposits from the throttle body assembly

PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

Hide 3.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

a.
A393488

Slide the clip and disconnect the No. 2 ventilation hose from the cylinder head cover sub-assembly.


b.

Disengage the 2 clamps.


c.
A393489

Disconnect the mass air flow meter connector and disengage the wire harness clamp.


d.

Loosen the hose clamp and disconnect the air cleaner hose assembly from the throttle body assembly.


e.
A393490

Disengage the 2 guides and remove the air cleaner cap with air cleaner hose from the air cleaner case sub-assembly.


Hide 22210 4.REMOVE THROTTLE BODY ASSEMBLY

a.
A393491C01
1.552,1.729 1.854,1.875 true 0.542,1.938 0.823,1.76 true 1.875,1.802 2.063,1.99 0.188,0.188 10 true *1 0.344,1.854 0.531,2.042 0.188,0.188 10 true *2
*1 No. 1 Water By-pass Hose
*2 No. 2 Water By-pass Hose


Disconnect the throttle body assembly connector.


b.

Slide the 2 clips and disconnect the No. 1 water by-pass hose and No. 2 water by-pass hose from the throttle body assembly.


c.
A393492C01
0.031,0.073 0.281,0.302 0.25,0.229 12 true *A 0.042,2.698 0.292,2.927 0.25,0.229 12 true *B
*A w/ Stud Bolt
*B w/o Stud Bolt


w/ Stud Bolt:

i.

Remove the 2 bolts, 2 nuts and throttle body assembly from the intake manifold.

NOTICE:

If the throttle body assembly has been struck or dropped, replace it.




d.

w/o Stud Bolt:

i.

Remove the 4 bolts and throttle body assembly from the intake manifold.

NOTICE:

If the throttle body assembly has been struck or dropped, replace it.




Hide 22271 5.REMOVE THROTTLE BODY GASKET

a.
A393493

Remove the throttle body gasket from the intake manifold.