11101E
1.INSTALL CAMSHAFT POSITION SENSOR (for Intake Side)
| *1 | O-ring |
Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.
If the camshaft position sensor has been struck or dropped, replace it.
Make sure that the O-ring is not cracked or does not move out of place during installation.
Connect the camshaft position sensor connector.
11101E
2.INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side)
| *1 | O-ring |
Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.
If the camshaft position sensor has been struck or dropped, replace it.
Make sure that the O-ring is not cracked or does not move out of place during installation.
Connect the camshaft position sensor connector.
3.INSPECT FOR OIL LEAK
11212
4.INSTALL NO. 2 CYLINDER HEAD COVER