11212
1.REMOVE NO. 2 CYLINDER HEAD COVER
11101E
2.REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)
Disconnect the camshaft position sensor connector.
Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.
If the camshaft position sensor has been struck or dropped, replace it.
11101E
3.REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)
Disconnect the camshaft position sensor connector.
Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.
If the camshaft position sensor has been struck or dropped, replace it.