Home › Engine / Hybrid System › 3ZR-FAE (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM32H0E _51 Engine / Hybrid System _059607 3ZR-FAE ENGINE CONTROL _0293876 CRANKSHAFT POSITION SENSOR A

3ZR-FAE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL RH

Hide 51443C 2.REMOVE REAR ENGINE UNDER COVER RH

Hide 11401G 3.REMOVE CRANKSHAFT POSITION SENSOR

a.
A393500

Disconnect the crankshaft position sensor connector.


b.

Remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.

NOTICE:

If the crankshaft position sensor has been struck or dropped, replace it.