Home › Engine / Hybrid System › 3ZR-FAE (ENGINE CONTROL) › IGNITION COIL AND SPARK PLUG
RM32H0E _51 Engine / Hybrid System _059607 3ZR-FAE ENGINE CONTROL _0293877 IGNITION COIL AND SPARK PLUG A

3ZR-FAE ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the ignition coil assembly or spark plug removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of ignition coil assembly Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Replacement of spark plug

PROCEDURE

Hide 19500 2.REMOVE IGNITION COIL ASSEMBLY

a.
A393503

Disconnect the 4 ignition coil assembly connectors.


b.

Remove the 4 bolts and 4 ignition coil assemblies from the cylinder head cover sub-assembly.

NOTICE:

If an ignition coil assembly has been struck or dropped, replace it.


HINT:

Arrange the removed parts in the correct order.



Hide 19100P 3.REMOVE SPARK PLUG