Home › Engine / Hybrid System › 3ZR-FAE (ENGINE CONTROL) › KNOCK SENSOR
RM32H0E _51 Engine / Hybrid System _059607 3ZR-FAE ENGINE CONTROL _0293880 KNOCK SENSOR A

3ZR-FAE ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


PROCEDURE

Hide 89615 1.INSTALL KNOCK SENSOR

HINT:

Perform "Inspection After Repair" after replacing the knock sensor.

Click hereEngine / Hybrid System>3ZR-FAE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.
A393513C01
1.802,3.979 2.063,4.156 0.26,0.177 10 true 20° 1.438,3.979 1.698,4.156 0.26,0.177 10 true 20°
V100136

Upper of Vehicle


Install the knock sensor to the cylinder block sub-assembly with the bolt so that the knock sensor installation position is as shown in the illustration.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)

NOTICE:
·

If the knock sensor has been struck or dropped, replace it.

·

Make sure that the knock sensor is in the correct position.




b.

Connect the knock sensor connector.


Hide 3.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the knock sensor.

Click hereEngine / Hybrid System>3ZR-FAE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION