Home › Engine / Hybrid System › 3ZR-FAE (ENGINE CONTROL) › AIR FUEL RATIO SENSOR
RM32H0E _51 Engine / Hybrid System _059607 3ZR-FAE ENGINE CONTROL _0293882 AIR FUEL RATIO SENSOR A

3ZR-FAE ENGINE CONTROL  AIR FUEL RATIO SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of air fuel ratio sensor Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Gas leak from exhaust system is repaired

CAUTION:
·
A344783

When the engine is hot, do not touch high-temperature areas such as the engine or exhaust manifold.

·

Touching high-temperature areas such as the engine and exhaust manifold could result in burns.



PROCEDURE

Hide 17410 1.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Front and Rear Catalyst)

Hide 58151 2.REMOVE NO. 1 FRONT FLOOR HEAT INSULATOR

a.
A393546

Remove the 3 nuts and No. 1 front floor heat insulator from the vehicle.


Hide 89467B 3.REMOVE AIR FUEL RATIO SENSOR

a.
A393519

Disconnect the air fuel ratio sensor connector.


b.

Disengage the 2 clamps.


c.
A393520E01
1.583,1.771 1.865,1.417 true 1.25,1.698 1.573,1.885 0.323,0.188 10 true SST

Using SST, remove the air fuel ratio sensor from the exhaust manifold.

SST
09224-00012  

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.