Home › Engine / Hybrid System › 8NR-FTS (INTAKE / EXHAUST) › EXHAUST PIPE (for 2WD) › 2016.10–2018.05
RM32H0E _51 Engine / Hybrid System _059908 8NR-FTS INTAKE / EXHAUST _0293892 EXHAUST PIPE(for 2WD) A

8NR-FTS INTAKE / EXHAUST  EXHAUST PIPE(for 2WD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front exhaust pipe assembly (TWC: Rear Catalyst) and tail exhaust pipe assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Gas leak from exhaust system is repaired Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
A344784

·

When the engine is hot, do not touch high-temperature areas such as the engine or exhaust pipe.

·

Touching high-temperature areas such as the engine and exhaust pipe could result in burns.



PROCEDURE

Hide 17430 1.REMOVE TAIL EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A392867

Remove the 2 bolts and 2 compression springs and disconnect the tail exhaust pipe assembly from the front exhaust pipe assembly (TWC: Rear Catalyst).


b.

Remove the tail exhaust pipe assembly from the 4 exhaust pipe supports.


c.

Remove the exhaust pipe gasket from the front exhaust pipe assembly (TWC: Rear Catalyst).


Hide 58166 2.REMOVE FRONT FLOOR COVER LH (w/ Cover)

a.
A392864C01
0,0 0,0 false
V100135

Bolt
V100136

Clip


Remove the 2 bolts, clip and disengage the 5 clamps to remove the front floor cover LH from the vehicle body.


Hide 58165B 3.REMOVE FRONT FLOOR COVER RH (w/ Cover)

HINT:

Perform the same procedure as for the front floor cover LH.


Hide 57533B 4.REMOVE FRONT FLOOR CENTER BRACE

a.
A392865

Remove the 12 bolts and 3 front floor center braces from the vehicle body.


Hide 17410 5.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

a.
A396115

Disengage the clamp and disconnect the heated oxygen sensor connector.


b.
A392869

Remove the 2 bolts and 2 compression springs and disconnect the front exhaust pipe assembly (TWC: Rear Catalyst) from the exhaust manifold converter sub-assembly (TWC: Front Catalyst).


c.

Remove the front exhaust pipe assembly (TWC: Rear Catalyst) from the 2 exhaust pipe supports.


d.

Remove the exhaust pipe gasket from the exhaust manifold converter sub-assembly (TWC: Front Catalyst).