Home › Engine / Hybrid System › 8NR-FTS (ENGINE CONTROL) › HEATED OXYGEN SENSOR
RM32H0E _51 Engine / Hybrid System _059353 8NR-FTS ENGINE CONTROL _0295077 HEATED OXYGEN SENSOR A

8NR-FTS ENGINE CONTROL  HEATED OXYGEN SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the heated oxygen sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Gas leak from exhaust system is repaired Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
·
A344784

When the engine is hot, do not touch high-temperature areas such as the engine or exhaust pipe.

·

Touching high-temperature areas such as the engine and exhaust pipe could result in burns.



PROCEDURE

Hide 17410 1.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

Hide 89465 2.REMOVE HEATED OXYGEN SENSOR

a.

for 2WD:

i.
A396210

Disengage the wire harness clamp.


ii.

Remove the wire harness clamp bracket from the heated oxygen sensor.


iii.
A396211N01
1.292,0.74 1.115,0.198 false 0.823,0.125 1.281,0.323 0.458,0.198 10 false SST

Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly (TWC: Rear Catalyst).

SST
09224-00012  

NOTICE:

If the heated oxygen sensor has been struck or dropped, replace it.




b.

for AWD:

i.
A393548

Disengage the wire harness clamp.


ii.

Remove the wire harness clamp bracket from the heated oxygen sensor.


iii.
A393632N01
0.948,0.135 1.135,0.448 false 0.635,0.052 1,0.25 0.365,0.198 10 false SST

Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly (TWC: Rear Catalyst).

SST
09224-00012  

NOTICE:

If the heated oxygen sensor has been struck or dropped, replace it.