| *a | Tube |
Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reassembly of the fuel suction tube with pump and gauge assembly to be impossible as the tube is pressed into the fuel suction plate sub-assembly.
When replacing the fuel filter, replace it together with the fuel suction plate sub-assembly.
83320
1.REMOVE FUEL SENDER GAUGE ASSEMBLY
23221
2.REMOVE FUEL PUMP
Disconnect the fuel pump harness connector.
| *a | Fuel Pump Filter Hose |
Disengage the clamp and claw, and disconnect the fuel pump filter hose from the No. 1 fuel sub-tank.
| *a | Tube |
| *b | Fuel Sub-tank |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the fuel filter and fuel pump from the fuel sub-tank.
Do not do anything which may separate the tube from either the fuel suction plate sub-assembly or fuel filter, such as applying excessive force to the tube.
Click hereEngine / Hybrid System>8NR-FTS (FUEL)>FUEL SYSTEM>PRECAUTION
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the No. 1 fuel suction support from the fuel filter.
| *a | Fuel Filter |
| *b | Suction Filter |
| *c | Tube |
Using a screwdriver with its tip wrapped with protective tape, disengage the 5 claws, and remove the fuel pump from the fuel filter.
Do not damage the fuel filter or suction filter.
Do not remove the suction filter from the fuel pump.
Do not do anything which may separate the tube from either the fuel suction plate sub-assembly or fuel filter, such as applying excessive force to the tube.
Click hereEngine / Hybrid System>8NR-FTS (FUEL)>FUEL SYSTEM>PRECAUTION
Disconnect the fuel pump harness connector to remove the fuel pump harness from the fuel pump.
| *1 | O-ring |
| *2 | Fuel Pump Spacer |
| *a | 5.0 mm (0.197 in.) |
Remove the O-ring and fuel pump spacer from the fuel pump.
Be careful not to damage the sealing surface.
If the O-ring still remains in the fuel filter, remove it using a wire tip (1 mm (0.0394 in.) diameter) that is formed as shown in the illustration.