Home › Engine / Hybrid System › 8NR-FTS (FUEL) › FUEL SENDER GAUGE ASSEMBLY (for AWD)
RM32H0E _51 Engine / Hybrid System _059909 8NR-FTS FUEL _0293906 FUEL SENDER GAUGE ASSEMBLY(for AWD) A

8NR-FTS FUEL  FUEL SENDER GAUGE ASSEMBLY(for AWD)  INSTALLATION  


PROCEDURE

Hide 83320B 1.INSTALL NO. 2 FUEL SENDER GAUGE ASSEMBLY

a.

Engage the claw to install the No. 2 fuel sender gauge assembly to the fuel tank vent tube assembly.

NOTICE:

Be careful not to bend the arm of the No. 2 fuel sender gauge assembly.



b.

Connect the No. 2 fuel sender gauge assembly connector.


c.

Engage the 2 clamps to connect the wire harness.

NOTICE:

Do not damage the wire harness.



Hide 77010 2.INSTALL FUEL TANK VENT TUBE ASSEMBLY

a.

Install a new fuel suction tube set gasket to the fuel tank assembly.


b.

Connect the fuel return vent tube sub-assembly and install the fuel tank vent tube assembly to the fuel tank assembly.

NOTICE:
A509845C01
2.01,1.927 2.01,1.708 true 1.927,1.927 2.115,2.094 0.188,0.167 10 false *1
*1 Fuel Return Vent Tube Sub-assembly
V100135

Front of the Vehicle


·

Make sure to correctly assemble the fuel return vent tube sub-assembly as shown in the illustration. If assembled incorrectly, the fuel sender gauge assembly (No. 2 fuel sender gauge assembly) may catch on the fuel return vent tube resulting in incorrect operation of the fuel sender gauge assembly (No. 2 fuel sender gauge assembly) and an incorrect value being displayed on the fuel gauge.

·

When connecting the fuel tube connector, do not excessively pull on the fuel return vent tube sub-assembly.

·

Be careful not to bend the arm of the No. 2 fuel sender gauge assembly.




c.

Align the protrusions of the fuel tank vent tube assembly with the notches in the fuel tank assembly.

HINT:

Perform the same procedure as for the fuel suction tube with pump and gauge assembly.

Click hereEngine / Hybrid System>8NR-FTS (FUEL)>FUEL PUMP (for AWD)>INSTALLATION



Hide 77144 3.INSTALL FUEL PUMP GAUGE RETAINER

HINT:

Perform the same procedure as for the fuel suction tube with pump and gauge assembly.

Click hereEngine / Hybrid System>8NR-FTS (FUEL)>FUEL PUMP (for AWD)>INSTALLATION


Hide 58325E 4.INSTALL REAR FLOOR SERVICE HOLE COVER RH

a.

Remove any remaining butyl tape from the rear floor service hole cover RH and vehicle body.


b.

Clean the installation surfaces of the rear floor service hole cover RH and vehicle body.


c.

Connect the fuel return vent tube sub-assembly connector.


d.

Install the rear floor service hole cover RH with new butyl tape.


Hide 83320 5.INSTALL FUEL SENDER GAUGE ASSEMBLY

a.

Engage the claw to install the fuel sender gauge assembly to the fuel suction tube with pump and gauge assembly.

NOTICE:

Be careful not to bend the arm of the fuel sender gauge assembly.



b.

Connect the fuel sender gauge assembly connector.


c.

Install the harness protector to the wire harness.

NOTICE:

Do not damage the wire harness.



d.

Engage the 2 clamps to connect the wire harness.

NOTICE:

Do not damage the wire harness.



Hide 77020A 6.INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY