Home › Engine / Hybrid System › 8NR-FTS (LUBRICATION) › OIL PRESSURE SENSOR
RM32H0E _51 Engine / Hybrid System _060037 8NR-FTS LUBRICATION _0294097 OIL PRESSURE SENSOR A

8NR-FTS LUBRICATION  OIL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 83520 1.INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

a.
A304094C10
1.469,0.344 1.646,0.344 1.646,0.344 1.927,0.688 false 1.813,1.229 2.01,1.563 2.01,1.563 2.24,1.563 false 1.302,0.229 1.615,0.385 0.313,0.156 10 false *a 2.281,1.458 2.594,1.615 0.313,0.156 10 false *b
*a Adhesive 1344
*b Oil Inlet Port


Apply adhesive to 2 or 3 threads of the oil pressure sender gauge assembly.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent


NOTICE:
·

Do not apply adhesive to the oil inlet port of the oil pressure sender gauge assembly.

·

To prevent contamination by foreign matter, install immediately after applying adhesive.




b.

Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine within 1 hour of installation.



c.

Connect the oil pressure sender gauge assembly connector.


Hide 2.INSPECT FOR ENGINE OIL LEAK

Hide 51443C 3.INSTALL REAR ENGINE UNDER COVER RH