Home › Engine / Hybrid System › 8NR-FTS (LUBRICATION) › OIL PRESSURE SENSOR
RM32H0E _51 Engine / Hybrid System _060037 8NR-FTS LUBRICATION _0294097 OIL PRESSURE SENSOR A

8NR-FTS LUBRICATION  OIL PRESSURE SENSOR  REMOVAL  


PROCEDURE

Hide 51443C 1.REMOVE REAR ENGINE UNDER COVER RH

Hide 83520 2.REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY

a.

Disconnect the oil pressure sender gauge assembly connector.


b.
A386467

Using a 27 mm deep socket wrench, remove the oil pressure sender gauge assembly.

NOTICE:

If the engine oil pressure switch assembly is dropped or subjected to a strong impact, replace it with a new one.