Home › Engine / Hybrid System › 8NR-FTS (LUBRICATION) › OIL PRESSURE SWITCHING VALVE
RM32H0E _51 Engine / Hybrid System _060037 8NR-FTS LUBRICATION _0294098 OIL PRESSURE SWITCHING VALVE A

8NR-FTS LUBRICATION  OIL PRESSURE SWITCHING VALVE  INSTALLATION  


PROCEDURE

Hide 1.INSTALL OIL PRESSURE SWITCHING VALVE ASSEMBLY

a.
A353425C02
2.052,1.25 2.25,0.833 2.25,0.833 2.469,0.833 false 2.521,0.719 2.833,0.875 0.313,0.156 10 false *a
*a O-Ring


Apply a small amount of engine oil to the O-ring of the oil pressure switching valve assembly.


b.
A351848C03
1.802,1.094 1.969,0.76 1.969,0.76 2.198,0.76 true 2.25,0.635 2.469,0.833 0.219,0.198 10 true *a 1.813,1.563 2.031,1.76 0.219,0.198 10 true *b
*a 10 mm Union Nut Wrench
*b Torque Wrench Fulcrum Length


Using a 10 mm union nut wrench, install the oil pressure switching valve assembly to the oil pump relief valve housing assembly with the bolt.

Torque:
Specified tightening torque : 8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:
·

When reusing the oil pressure switching valve assembly, inspect the O-ring.

·

Make sure that the O-ring is not cracked or does not move out of place during installation.



HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a 10 mm union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)): 8.0 N*m (82 kgf*cm, 71 in.*lbf)




c.

Connect the oil pressure switching valve assembly connector.


Hide 51443C 3.INSTALL REAR ENGINE UNDER COVER RH