Home › Audio / Visual / Telematics › TELEMATICS › MAYDAY BATTERY
RM32H0E _56 Audio / Visual / Telematics _060052 TELEMATICS _0294139 MAYDAY BATTERY A

TELEMATICS  MAYDAY BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the mayday battery removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Telematics transceiver Register vehicle information Emergency call service (Click here)
Mobilephone battery Reset mobilephone battery condition

PROCEDURE

Hide 86741A 1.REMOVE TELEMATICS TRANSCEIVER

Hide 86725 2.REMOVE MOBILEPHONE BATTERY

a.
E357310C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Loosen the 2 screws.


b.

Disengage the claws and guides to remove the cover sub-assembly as shown in the illustration.


c.
E357312

Disconnect the connector.


d.

Remove the mobilephone battery.