Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2016.10–2019.09
RM32H0E _58 Vehicle Interior _060136 METER / GAUGE / DISPLAY _0294876 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Entire Combination Meter does not Operate  


DESCRIPTION

This circuit is the power source circuit for the combination meter assembly. This circuit provides two types of power sources; one is a constant power source, and the other is an IG power source.

WIRING DIAGRAM

C360595E03
1.104,0.656 2.625,0.865 1.521,0.208 10 false from IG2-NO. 2 Relay*1 0.885,1.229 2.635,1.448 1.75,0.219 10 false from Stop and Start ECU*2 1.76,1.729 2.625,1.958 0.865,0.229 10 false from Battery 3.167,0.833 4.115,1.042 0.948,0.208 10 false METER-IG2*1 3.083,1.896 4.198,2.094 1.115,0.198 10 false ECU-DCC NO. 2 5.365,0.563 5.667,0.76 0.302,0.198 10 false IG+ 5.365,1.625 5.521,1.823 0.156,0.198 10 false B 5.365,2.385 5.677,2.583 0.313,0.198 10 false ET 5.104,0.563 5.417,0.76 0.313,0.198 10 false 39 5.104,1.625 5.417,1.823 0.313,0.198 10 false 40 5.104,2.281 5.417,2.479 0.313,0.198 10 false 21 5.188,3.021 5.5,3.219 0.313,0.198 10 false F4 5.177,3.188 7.021,3.396 1.844,0.208 10 false Combination Meter Assembly 0.167,3 2.24,3.219 2.073,0.219 10 false *1: w/o Stop and Start System 0.167,3.333 2.052,3.552 1.885,0.219 10 false *2: w/ Stop and Start System

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses of circuits related to this system before performing the following procedure.

·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY CIRCUIT)
a.

Disconnect the F4 combination meter assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F4-21 (ET) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F4-39 (IG+) - Body ground Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V
F4-40 (B) - Body ground Always 11 to 14 V



Result:
Proceed to
OK
NG



OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR