Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM32H0E _54 Brake _060039 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0294918 VEHICLE STABILITY CONTROL SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  Brake Warning Light does not Come ON  


DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the skid control ECU (brake actuator assembly), perform system variant learning.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION

·

Inspect the fuses for circuits related to this system before performing the following procedure.



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if CAN communication system DTCs are output.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM


Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B



A

2.PERFORM ACTIVE TEST USING GTS (BRAKE WARNING LIGHT)

B

2.PERFORM ACTIVE TEST USING GTS (BRAKE WARNING LIGHT)
a.

Select the Active Test on the GTS.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DATA LIST / ACTIVE TEST

Chassis > ABS/VSC/TRC/EPB > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Brake Warning Light Brake system warning light (red indicator) Warning light ON/OFF Observe combination meter assembly
Chassis > ABS/VSC/TRC/EPB > Active Test
Tester Display
Brake Warning Light
50004 105 12

b.

Select the Data List on the GTS.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DATA LIST / ACTIVE TEST

Chassis > ABS/VSC/TRC/EPB > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Brake Warning Light Brake system warning light (red indicator) ON or OFF ON: Warning light on
OFF: Warning light off
-
Chassis > ABS/VSC/TRC/EPB > Data List
Tester Display
Brake Warning Light
50003 105 52

c.

Check the operating condition of the brake system warning light (red indicator) when operating it using the GTS.


Result:
Result Proceed to
Brake system warning light (red indicator) in the Data List does not change using the Active Test. (for LHD) A
Brake system warning light (red indicator) in the Data List does not change using the Active Test. (for RHD) B
Brake system warning light (red indicator) in the Data List turns ON/OFF using the Active Test. C



A

B

C

3.INSPECT COMBINATION METER ASSEMBLY
3.INSPECT COMBINATION METER ASSEMBLY
a.

Perform the Active Test of the combination meter assembly using the GTS.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST

Body Electrical > Combination Meter > Active Test
Tester Display
Indicat. Lamp Brake
50004 122 21

b.

Check the combination meter assembly.

OK:

The brake system warning light (red indicator) turns on or off in accordance with the GTS.



Result:
Result Proceed to
OK (for LHD) A
OK (for RHD) B
NG C



A

B

C