Home › Engine / Hybrid System › 3ZR-FAE (FUEL) › FUEL PUMP
RM32H0E _51 Engine / Hybrid System _060184 3ZR-FAE FUEL _0295035 FUEL PUMP A

3ZR-FAE FUEL  FUEL PUMP  DISASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:
A396121C01
0.792,0.854 1.188,0.99 false 0.573,0.75 0.885,0.948 0.313,0.198 10 false *a
*a Tube


Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reassembly of the fuel suction tube with pump and gauge assembly to be impossible as the tube is pressed into the No. 1 plate sub-assembly.


PROCEDURE

Hide 83320 1.REMOVE FUEL SENDER GAUGE ASSEMBLY

Hide 23221 2.REMOVE FUEL PUMP

a.
A396122

Disconnect the fuel pump harness connector.


b.

Disengage the 2 clamps and disconnect the fuel pump harness from the fuel suction tube with pump and gauge assembly.


c.
A395513C04
2.729,0.51 2.99,0.385 true 3.063,0.281 3.375,0.438 0.313,0.156 10 false *1
*1 No. 1 Plate Sub-assembly
V100135

Pull
V100136

Slide


Disengage the claw and slide the No. 1 plate sub-assembly and then remove that from the fuel sub-tank sub-assembly.


d.
A338511

Disengage the 4 claws, and remove the fuel pump from the fuel sub-tank sub-assembly.


e.
A344814C01
2.896,2.594 3.083,2.333 false 2.177,2.958 2.313,3.208 false 3.135,2.25 3.344,2.406 0.208,0.156 10 false *1 2.365,3.177 2.677,3.333 0.313,0.156 10 false *2
*1 Fuel Pump
*2 No. 1 Fuel Suction Support


Disengage the 3 claws, and remove the fuel pump from the No. 1 fuel suction support.


f.
A393836

Disconnect the fuel pump harness connector to remove the fuel pump harness from the fuel pump.


g.
A344815C02
1.313,0.271 1.448,0.271 1.448,0.271 1.615,0.49 false 1.198,0.635 1.625,0.635 true 1.135,0.219 1.448,0.375 0.313,0.156 10 false *1 1.01,0.563 1.323,0.719 0.313,0.156 10 false *2
*1 O-ring
*2 Fuel Pump Spacer


Remove the O-ring and fuel pump spacer from the fuel pump.

NOTICE:

Be careful not to damage the sealing surface.


HINT:

If the O-ring still remains in the fuel filter, remove it using a wire tip (1 mm (0.0394 in.) diameter) that is formed as shown in the illustration.