Home › Engine / Hybrid System › 3ZR-FAE (EMISSION CONTROL) › PCV VALVE
RM32H0E _51 Engine / Hybrid System _060194 3ZR-FAE EMISSION CONTROL _0295050 PCV VALVE A

3ZR-FAE EMISSION CONTROL  PCV VALVE  INSTALLATION  


PROCEDURE

Hide 12204 1.INSTALL PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY)

a.
A092670C06
2.146,0.708 1.927,0.271 1.927,0.271 1.688,0.271 false 1.51,0.177 2.115,0.354 0.604,0.177 10 *a
*a Adhesive


Apply adhesive to 2 or 3 threads of the PCV valve (ventilation valve sub-assembly).

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



b.
A336064C02
1.448,1.229 1.667,1.427 0.219,0.198 10 true *a
*a Torque Wrench Fulcrum Length


Using a 22 mm ball joint lock nut wrench, install the PCV valve (ventilation valve sub-assembly) to the ventilation case.

Torque:
Specified tightening torque : 20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:

Do not start the engine for at least 1 hour after installation.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a 22 mm ball joint lock nut wrench (fulcrum length of 149.75 mm (5.9 in.)) + torque wrench (fulcrum length of 162 mm (6.4 in.)): 10 N*m (102 kgf*cm, 7 ft.*lbf)




Hide 12261 2.CONNECT VENTILATION HOSE

a.
A394540C01
2.01,3.656 2.01,3.99 false 1,3.021 0.75,2.927 false 1.938,4.01 2.25,4.167 0.313,0.156 10 false *1 2.625,2.625 2.938,2.781 0.313,0.156 10 false *a 1.292,3.927 1.604,4.083 0.313,0.156 10 false *b 1.104,2.583 1.417,2.74 0.313,0.156 10 false *c 0.688,3.927 1,4.083 0.313,0.156 10 false *b 0.583,2.823 0.896,3.021 0.313,0.198 10 false *d
*1 PCV valve (ventilation valve sub-assembly)
*a 4 to 10 mm (0.157 to 0.394 in.)
*b 30°
*c Top of Vehicle
*d Paint Mark


Connect the ventilation hose to the PCV valve (ventilation valve sub-assembly) and slide the clip to secure it.

HINT:

Engage the clip within the area shown in the illustration.