Home › Engine / Hybrid System › 8NR-FTS (ENGINE CONTROL) › CAMSHAFT OIL CONTROL VALVE (for Intake Side)
RM32H0E _51 Engine / Hybrid System _059353 8NR-FTS ENGINE CONTROL _0295062 CAMSHAFT OIL CONTROL VALVE(for Intake Side) A

8NR-FTS ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE(for Intake Side)  INSTALLATION  


PROCEDURE

Hide 13523F 1.INSTALL CAMSHAFT TIMING GEAR BOLT

NOTICE:
A394922C01
0.271,1.823 0.469,1.396 true 0.167,1.844 0.479,2 0.313,0.156 10 false *a
*a Identification Mark


There are different types of camshaft timing gear bolts. Make sure to check the identification mark to determine the tightening torque.

Identification Mark
Item Identification Mark
Type A A
Type B C


a.

Make sure that the No. 1 cylinder is at the TDC/compression.

HINT:

Check that the cutout of the camshaft timing gear assembly is at the top and align the timing mark (cutout) of the crankshaft pulley with the protrusion on the timing chain cover assembly.



b.
A352538

Apply engine oil to the areas of the camshaft timing gear bolt shown in the illustration.


c.

While holding the crankshaft pulley, temporarily install the camshaft timing gear bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the camshaft timing gear bolt has been struck or dropped, replace it.

·

If there is any abnormal resistance when temporarily installing the camshaft timing gear bolt, loosen it and make sure that the No. 1 cylinder is at TDC/compression, and then temporarily install the camshaft timing gear bolt again.



HINT:

Make sure that the flange part of the camshaft timing gear bolt contacts the entire circumference of the camshaft timing gear assembly.



d.

While holding the crankshaft pulley, loosen the camshaft timing gear bolt 60 to 180°.


e.

Turn the crankshaft pulley clockwise 70 to 110°.


f.

While holding the crankshaft pulley, tighten the camshaft timing gear bolt.

Torque:
for Type A : 120 N*m (1224 kgf*cm, 89 ft.*lbf)
for Type B : 95 N*m (969 kgf*cm, 70 ft.*lbf)

NOTICE:

Do not use an impact wrench.



Hide 15370 2.INSTALL CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Intake Side)

Hide 3.INSPECT FOR ENGINE OIL LEAK