Home › Engine / Hybrid System › 8NR-FTS (ENGINE CONTROL) › CAMSHAFT OIL CONTROL VALVE (for Intake Side)
RM32H0E _51 Engine / Hybrid System _059353 8NR-FTS ENGINE CONTROL _0295062 CAMSHAFT OIL CONTROL VALVE(for Intake Side) A

8NR-FTS ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE(for Intake Side)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the camshaft timing gear bolt removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of camshaft timing gear assembly Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 15370 1.REMOVE CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Intake Side)

Hide 2.SET NO. 1 CYLINDER TO TDC/COMPRESSION

a.
A352534C03
1.854,1.292 2.052,1.792 2.052,1.792 2.25,1.792 true 0.958,1.708 1.156,1.708 1.156,1.708 1.542,1.167 true 2.25,1.708 2.438,1.896 0.188,0.188 10 true *b 0.781,1.646 0.979,1.823 0.198,0.177 10 true *a
*a Timing Mark (Cutout)
*b Protrusion


Turn the crankshaft pulley clockwise until its timing mark (cutout) is aligned with the protrusion on the timing chain cover assembly as shown in the illustration.


b.
A354267C01
1.938,0.76 1.833,0.167 1.833,0.167 1.5,0.167 true 1.948,3.99 1.792,4.417 1.792,4.417 1.458,4.417 true 0.302,1.115 0.615,1.271 0.313,0.156 10 false *a 0.302,3.542 0.615,3.698 0.313,0.156 10 false *b 1.323,0.073 1.5,0.26 0.177,0.188 10 true *c 3,0.469 3.219,0.677 0.219,0.208 10 true *d 3,2.865 3.219,3.073 0.219,0.208 10 true *d 1.302,4.313 1.479,4.51 0.177,0.198 10 true *c
*a Correct
*b Incorrect
*c Cutout
*d Up


Check that the cutout of the camshaft timing gear assembly is at the top.

HINT:

If the cutout of the camshaft timing gear assembly is not at the top, turn the crankshaft 360° clockwise and align the timing mark (cutout) of the crankshaft pulley with the protrusion on the timing chain cover assembly again.



Hide 13523F 3.REMOVE CAMSHAFT TIMING GEAR BOLT

a.
A392681

While holding the crankshaft pulley, remove the camshaft timing gear bolt.

NOTICE:
·

If the camshaft timing gear bolt has been struck or dropped, replace it.

·

Do not turn the crankshaft pulley after removing the camshaft timing gear bolt.