Home › Engine / Hybrid System › 8NR-FTS (ENGINE CONTROL) › THROTTLE BODY
RM32H0E _51 Engine / Hybrid System _059353 8NR-FTS ENGINE CONTROL _0295065 THROTTLE BODY A

8NR-FTS ENGINE CONTROL  THROTTLE BODY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the throttle body with motor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of throttle body with motor assembly Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Cleaning the deposits from the throttle body with motor assembly

PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 22030 3.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

a.
A392693C01
0.417,2 0.583,2 0.583,2 0.698,1.583 true 1.875,2.021 1.719,2.021 1.719,2.021 1.542,1.75 true 0.198,1.885 0.385,2.052 0.188,0.167 10 true *1 1.896,1.927 2.083,2.094 0.188,0.167 10 true *2
*1 No. 1 Water By-pass Hose
*2 No. 2 Water By-pass Hose


Disconnect the throttle body with motor assembly connector.


b.

Slide the 2 clips and disconnect the No. 1 water by-pass hose and No. 2 water by-pass hose from the throttle body with motor assembly.


c.
A392694

Remove the 2 bolts and 2 nuts.


d.
A353242

Using an E6 "TORX" socket wrench, remove the 2 stud bolts.

NOTICE:

Do not drop the throttle body with motor assembly.



e.

Separate the intercooler assembly and remove the throttle body with motor assembly from the intake manifold.

NOTICE:

If the throttle body with motor assembly has been struck or dropped, replace it.



Hide 22271 4.REMOVE THROTTLE BODY GASKET

a.
A392697C01
1.146,1.427 1.365,1.604 0.219,0.177 10 true *a 1.521,1.573 1.698,1.74 0.177,0.167 10 true *b
*a Intercooler Assembly Side
*b Intake Manifold Side


Remove the throttle body gasket from the intercooler assembly.


b.

Remove the throttle body gasket from the intake manifold.