Home › Engine / Hybrid System › 8NR-FTS (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM32H0E _51 Engine / Hybrid System _059353 8NR-FTS ENGINE CONTROL _0295070 CRANKSHAFT POSITION SENSOR A

8NR-FTS ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL RH

Hide 51443C 2.REMOVE REAR ENGINE UNDER COVER RH

Hide 11301K 3.REMOVE CRANKSHAFT POSITION SENSOR

a.
A392710

Disconnect the crankshaft position sensor connector.


b.

Remove the bolt and crankshaft position sensor from the timing chain cover assembly.

NOTICE:

If the crankshaft position sensor has been struck or dropped, replace it.