Home › Engine / Hybrid System › 8NR-FTS (ENGINE CONTROL) › IGNITION COIL AND SPARK PLUG
RM32H0E _51 Engine / Hybrid System _059353 8NR-FTS ENGINE CONTROL _0295071 IGNITION COIL AND SPARK PLUG A

8NR-FTS ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the No. 1 ignition coil or spark plug removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of No. 1 ignition coil Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Replacement of spark plug

PROCEDURE

Hide 19500D 1.REMOVE NO. 1 IGNITION COIL

a.
A392712C01
2.385,1.438 2.583,1.625 0.198,0.188 10 true *a 3.198,0.625 3.375,0.781 0.177,0.156 10 true *b 2.76,1.229 2.969,1.406 0.208,0.177 10 true *c 2.802,1.656 2.979,1.833 0.177,0.177 10 true *d
*a Sensor Wire Connector
*b Fuel Pump Assembly Connector
*c No. 1 Ignition Coil Connector
*d Camshaft Position Sensor Connector


Disconnect the sensor wire connector.


b.

Disconnect the fuel pump assembly connector.


c.

Disconnect the No. 1 ignition coil connector.


d.

Disconnect the camshaft position sensor connector.


e.

Disengage the 2 clamps.


f.

Remove the nut and separate the engine wire from the cylinder head cover sub-assembly.


g.
A392713

Disconnect the 3 No. 1 ignition coil connectors.


h.
A392714

Remove the 4 bolts and 4 No. 1 ignition coils from the cylinder head cover sub-assembly.

NOTICE:

If a No. 1 ignition coil has been struck or dropped, replace it.


HINT:

Arrange the removed parts in the correct order.



Hide 19100P 2.REMOVE SPARK PLUG