Home › General › MAINTENANCE › 8NR-FTS SPARK PLUG
RM32H0E _V1 General _059503 MAINTENANCE _0295151 8NR-FTS SPARK PLUG A

MAINTENANCE  8NR-FTS SPARK PLUG  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the ignition coil assembly or spark plug removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of ignition coil assembly Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Replacement of spark plug

PROCEDURE

Hide 19100P 2.REMOVE SPARK PLUG

a.
A392715

Using a 14 mm spark plug wrench, remove the 4 spark plugs from the cylinder head sub-assembly.

NOTICE:

If a spark plug has been struck or dropped, replace it.


HINT:

Arrange the removed parts in the correct order.