Home › Engine / Hybrid System › 8NR-FTS (ENGINE CONTROL) › ENGINE COOLANT TEMPERATURE SENSOR
RM32H0E _51 Engine / Hybrid System _059353 8NR-FTS ENGINE CONTROL _0295072 ENGINE COOLANT TEMPERATURE SENSOR A

8NR-FTS ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89422A 1.INSTALL ENGINE COOLANT TEMPERATURE SENSOR

HINT:

Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

Click hereEngine / Hybrid System>8NR-FTS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.

Apply a light coat of engine coolant to the O-ring of the engine coolant temperature sensor.


b.

Install the engine coolant temperature sensor to the water outlet with the clip.

NOTICE:
·

If the engine coolant temperature sensor has been struck or dropped, replace it.

·

If reusing the engine coolant temperature sensor, be sure to inspect the O-ring.

·

Make sure that the O-ring is not cracked or moved out of place when installing the engine coolant temperature sensor.




c.

Connect the engine coolant temperature sensor connector.


Hide 51441 4.INSTALL NO. 1 ENGINE UNDER COVER

Hide 5.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

Click hereEngine / Hybrid System>8NR-FTS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION