Home › Engine / Hybrid System › 8NR-FTS (ENGINE CONTROL) › ENGINE COOLANT TEMPERATURE SENSOR
RM32H0E _51 Engine / Hybrid System _059353 8NR-FTS ENGINE CONTROL _0295072 ENGINE COOLANT TEMPERATURE SENSOR A

8NR-FTS ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine coolant temperature sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of engine coolant temperature sensor Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 89422A 3.REMOVE ENGINE COOLANT TEMPERATURE SENSOR

a.
A392718

Disconnect the engine coolant temperature sensor connector.


b.
A392719

Remove the clip and engine coolant temperature sensor from the water outlet.

NOTICE:

If the engine coolant temperature sensor has been struck or dropped, replace it.