Home › Engine / Hybrid System › 8NR-FTS (COOLING) › THERMOSTAT › 2016.10–2019.09
RM32H0E _51 Engine / Hybrid System _060195 8NR-FTS COOLING _0295083 THERMOSTAT A

8NR-FTS COOLING  THERMOSTAT  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the water inlet with thermostat sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*1: When performing learning using the GTS

Click here(Click here)

*2: w/ Stop and start system

Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision syatem
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system (Click here)

PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 16572D 4.DISCONNECT NO. 2 RADIATOR HOSE

Hide 16267 5.DISCONNECT NO. 3 WATER BY-PASS HOSE (for CVT)

a.
A350054

Slide the clip and disconnect the No. 3 water by-pass hose from the water inlet with thermostat sub-assembly.


Hide 16267C 6.DISCONNECT NO. 4 WATER BY-PASS HOSE (for Manual Transaxle)

a.
A350054

Slide the clip and disconnect the No. 4 water by-pass hose from the water inlet with thermostat sub-assembly.


Hide 16031 7.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

a.
A350055

Remove the 2 bolts and water inlet with thermostat sub-assembly.


Hide 16326 8.REMOVE NO. 2 WATER INLET HOUSING GASKET

A350056

a.

Remove the No. 2 water inlet housing gasket from the water inlet with thermostat sub-assembly.