Home › General › MAINTENANCE › 8NR-FTS BATTERY › 2016.10–2019.09
RM32H0E _V1 General _059503 MAINTENANCE _0295270 8NR-FTS BATTERY A

MAINTENANCE  8NR-FTS BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the battery removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

*2: w/ Stop and start system

Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system*2 (Click here)
Replacement of battery
·

Clear the integrated current value

·

Switch battery type


Stop and start system*2 (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

a.
A387996

Loosen the nut and disconnect the cable from the negative (-) battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



Hide 28800 3.REMOVE BATTERY

a.
A387997

Disengage the 2 claws to remove the fusible link cover.


b.
A387998

Loosen the nut.


c.
A394392

Disengage the clamp and disconnect the cable from the positive (+) battery terminal.


d.
A394386

Remove the battery insulator from the battery.


e.
A387999

Remove the bolt and No. 2 battery clamp.


f.
A394387

Remove the battery from the vehicle.