Home › General › INTRODUCTION › REPAIR INSTRUCTION › 2016.10–2018.05
RM32H0E _V1 General _059286 INTRODUCTION _0290171 REPAIR INSTRUCTION D

INTRODUCTION  REPAIR INSTRUCTION  INITIALIZATION  


PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED/RECONNECTED


Necessary Procedures Effect/Inoperative Function when Necessary Procedures not Performed Link
Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system (Click here)


NOTICE:
·

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 90 seconds before disconnecting the cable from the negative (-) battery terminal (for Audio and Visual System).

·

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 90 seconds before disconnecting the cable from the negative (-) battery terminal (for Navigation System (for Radio and Display Type)).




PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Replacement Part Necessary Procedure Effect/Inoperative Function when Necessary Procedures not Performed Link
ECM Perform Vehicle Identification Number (VIN) registration MIL comes on for 8NR-FTS
(Click here)
Heavy knock history registration DTC are stored
ECU Communication ID Registration (Immobiliser system) Engine start function See Service Bulletin for the registration method.
Piston ring Clear heavy knock history - for 8NR-FTS
(Click here)
·

Throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly

·

Cylinder head sub-assembly

·

Camshaft (for intake or exhaust camshaft)

·

Camshaft timing gear assembly

·

Camshaft timing exhaust gear assembly

·

Piston or piston ring

·

Mass air flow meter

·

Fuel injector assembly

·

Fuel pump (for low pressure side)

·

Fuel pump assembly (for high pressure side)

·

Air fuel ratio sensor

·

Engine coolant temperature sensor

·

Spark plug

·

No. 1 Ignition coil assembly

·

Air leaks from intake system

·

Gas leaks from exhaust system


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


ECM Perform Vehicle Identification Number (VIN) registration MIL comes on for 3ZR-FAE
(Click here)
ECU Communication ID Registration (Immobiliser system) Engine start function See Service Bulletin for the registration method.
·

Throttle body assembly

·

Cleaning the deposits from the throttle body assembly

·

Engine assembly

·

Continuously variable valve lift controller assembly

·

Cylinder head sub-assembly

·

Camshaft housing sub-assembly

·

Camshaft timing gear assembly

·

Camshaft timing exhaust gear assembly

·

Piston or piston ring

·

Mass air flow meter

·

Fuel injector assembly

·

Fuel pump

·

Air fuel ratio sensor

·

Engine coolant temperature sensor

·

Spark plug

·

Ignition coil assembly

·

Air leaks from intake system

·

Gas leaks from exhaust system


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


for 3ZR-FAE
(Click here)
Engine stop and start ECU
1.

Upload the number of starter operations

2.

Reset air conditioning information

3.

Learning of air conditioning information

4.

Clear the zero point calibration data

5.

Perform zero point calibration of the deceleration sensor


Stop and start system (Click here)
Air conditioning amplifier assembly
1.

Reset air conditioning information

2.

Learning of air conditioning information


Starter assembly Clear the number of starter operations
Airbag sensor assembly
1.

Clear the zero point calibration data

2.

Perform zero point calibration of the deceleration sensor


Battery
·

Clear the integrated current value

·

Switch battery type


·

Continuously variable transaxle assembly

·

ECM

·

Oil pressure sensor

·

Airbag sensor assembly


1.

Reset memory

2.

Deceleration sensor zero point calibration

3.

CVT oil pressure calibration


Deterioration of fuel efficiency for K313(Click here)
for K313F(Click here)
CVT fluid ATF Thermal Degradation Estimate Reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly
·

Continuously variable transaxle assembly

·

ECM

·

Oil pressure sensor

·

Airbag sensor assembly


1.

Reset memory

2.

Deceleration sensor zero point calibration

3.

CVT oil pressure calibration


Deterioration of fuel efficiency for K114
(Click here)
CVT fluid ATF Thermal Degradation Estimate Reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly
Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly
·

Dynamic radar cruise control system

·

Pre-collision system

·

Forward recognition camera system

·

Lane departure alert system (w/ Steering Control)

·

Road sign assist system


(Click here)
·

Forward recognition camera

·

Windshield glass


Adjust forward recognition camera
·

Dynamic radar cruise control system

·

Lane departure alert system (w/ Steering Control)

·

Pre-collision system

·

Forward recognition camera system

·

Automatic high beam system


(Click here)
·

Tire pressure warning ECU and receiver

·

Tire pressure warning valve and transmitter


·

Register transmitter ID

·

Initialize tire pressure warning system


·

When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

·

Tire pressure warning function


for Registration(Click here)
for Initialization(Click here)
4WD ECU assembly
HINT:

When replacing the 4WD ECU assembly with a new one, it is not necessary to perform initialization.


Clear zero point calibration data Dynamic torque control AWD system (Click here)
Skid control ECU (brake actuator assembly) Operate the electric parking brake switch assembly Parking brake indicator light (red) blinks when the ignition switch is first turned on (IG) (Click here)
1.

Clear zero point calibration data.

2.

Perform yaw rate and acceleration sensor zero point calibration.


·

DTCs are stored

·

ABS warning light illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)
Airbag sensor assembly
1.

Clear zero point calibration data.

2.

Perform yaw rate and acceleration sensor zero point calibration.


Power steering ECU assembly
·

Torque sensor zero point calibration

·

Assist map writing


·

DTCs are stored

·

EPS warning light illuminates


(Click here)
Electric power steering column sub-assembly Torque sensor zero point calibration
Telematics transceiver Register vehicle information Emergency call service (Click here)
Mobilephone battery Reset mobilephone battery condition
Steering sensor Steering angle neutral point (Initialize panoramic view monitor system) Simple Intelligent Parking Assist System (Click here)
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)
Clearance warning ECU assembly
·

Steering angle neutral point

·

Registration of bumper type


·

Simple Intelligent Parking Assist System

·

Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)


(Click here)
Registration of bumper type Toyota parking assist-sensor system (w/o Simple Intelligent Parking Assist System) (Click here)
Blind spot monitor sensor Blind spot monitor beam axis adjustment DTCs are output (Click here)
·

Certification ECU (smart key ECU assembly)

·

ID code box (immobiliser code ECU)

·

Steering lock ECU (steering lock actuator assembly)

·

Electrical key transmitter sub-assembly

·

Main body ECU (multiplex network body ECU)

·

ECM


Perform code registration (Immobiliser system)
·

Wireless door lock control system

·

Entry and start system

·

Engine start function

·

Steering lock system


See Service Bulletin for the registration method. (w/ Entry and Start System)
·

Door control transmitter

·

ECM

·

Transponder key ECU assembly


Perform code registration (Immobiliser system) Engine starting See Service Bulletin for the registration method. (w/o Entry and Start System)
·

Door control transmitter

·

Door control receiver


Register recognition code Wireless door lock operation w/o Entry and Start System(Click here)
AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System with Top-mounted Air Conditioner Pressure Sensor)
·

No. 1 Blower Damper Servo Sub-assembly (FRESH/RECIRCULATION)

·

No. 1 Air Conditioning Radiator Damper Servo Sub-assembly (Front Passenger Side Upper Air Mix)

·

No. 1 Air Conditioning Radiator Damper Servo Sub-assembly (Driver Side Upper Air Mix)

·

No. 1 Air Conditioning Radiator Damper Servo Sub-assembly (Driver Side Lower Air Mix)

·

No. 2 Air Conditioning Radiator Damper Servo Sub-assembly (Mode Switching)

·

No. 1 Air Conditioning Radiator Damper Servo Sub-assembly (Front Passenger Side Lowerr Air Mix)

·

Air conditioning amplifier assembly


Initialize servo motor (Air conditioning system) DTCs are stored (Click here)
AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System with Side-mounted Air Conditioner Pressure Sensor)
·

No. 1 air conditioning radiator damper servo sub-assembly

·

No. 1 blower damper servo sub-assembly

·

Air conditioning amplifier assembly


Initialize servo motor (Air conditioning system) DTCs are stored (Click here)
AIR CONDITIONING SYSTEM (for Manual Air Conditioning System)
·

No. 1 Blower Damper Servo Sub-assembly (FRESH/RECIRCULATION)

·

No. 1 Air Conditioning Radiator Damper Servo Sub-assembly (Upper Air Mix)

·

No. 1 Air Conditioning Radiator Damper Servo Sub-assembly (Lower Air Mix)

·

No. 2 Air Conditioning Radiator Damper Servo Sub-assembly (Mode Switching)

·

Air conditioning amplifier assembly


Initialize servo motor (Air conditioning system) DTCs are stored (Click here)
·

Door window regulator assembly

·

Power window regulator motor assembly

·

Door glass

·

Door glass run


Initialize power window control system
·

Auto up and down function

·

Jam protection function

·

Catch protection function

·

Remote control function

·

Key-linked function

·

Wireless transmitter-linked function

·

Key-off operation function

·

Window open warning function


(Click here)
·

Rear height control sensor sub-assembly LH

·

Suspension, tires, etc.*1


Initialize headlight ECU sub-assembly LH Automatic headlight beam level control system (Click here)
Headlight ECU sub-assembly LH
·

Synchronize vehicle information

·

Initialize headlight ECU sub-assembly LH




*1: The vehicle height changes because of suspension or tire replacement.