Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING AMPLIFIER
RM32H0E _58 Vehicle Interior _059841 HEATING / AIR CONDITIONING _0295320 AIR CONDITIONING AMPLIFIER A

HEATING / AIR CONDITIONING  AIR CONDITIONING AMPLIFIER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the air conditioning amplifier assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effects / Inoperative when not performed Link
Air conditioning amplifier assembly Initialize servo motor (Air conditioning system) DTCs are stored for VALEO Made:
(Click here)
for DENSO Made:
(Click here)

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The following procedure is for the LHD vehicles.



PROCEDURE

Hide 67914 1.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 62112 2.REMOVE COWL SIDE TRIM BOARD LH

Hide 55606 3.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 88650N 4.REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY

a.

for VALEO Made:

i.
I112426

Remove the screw.


ii.
I112427C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the guides to remove the air conditioning amplifier assembly as shown in the illustration.


iii.
I112428

Disconnect each connector.



b.

for DENSO Made:

i.
E344317

Remove the screw.


ii.
E344318C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the guide to remove the air conditioning amplifier assembly as shown in the illustration.


iii.
E344319

Disconnect each connector.