Home › Vehicle Exterior › DOOR / HATCH › HOOD
RM32H0E _59 Vehicle Exterior _060017 DOOR / HATCH _0295663 HOOD N

DOOR / HATCH  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

B360727C02
0.656,0.24 0.969,0.396 0.313,0.156 10 false *a 2.469,0.24 2.781,0.396 0.313,0.156 10 false *b
*a Centering Bolt
*b Standard Bolt


HINT:
·

Centering bolts are used to install the hood hinges and hood lock. The hood and hood lock cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts with washers when making adjustments.

·

The specified torque for standard bolts is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 1.INSPECT HOOD SUB-ASSEMBLY

Hide 2.REMOVE FRONT BUMPER ASSEMBLY

Hide 3.ADJUST HOOD SUB-ASSEMBLY

a.

Horizontally and vertically adjust the hood.

i.
B450721

Loosen the 4 hinge bolts of the hood.


ii.

Adjust the clearance between the hood and front fenders by moving the hood.


iii.

Tighten the 4 hinge bolts after adjustment.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)



b.
B450722

Adjust the height of the front end of the hood using the hood bumper cushions.

i.

Adjust the 2 hood bumper cushions so that the heights of the hood and fenders are aligned.

HINT:

Raise or lower the front end of the hood by turning the 2 hood bumper cushions.




c.

Adjust the hood lock.

i.
B450723C01
0.979,1.667 1.396,0.885 true 0.854,1.677 1.104,1.927 0.25,0.25 10 true *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, remove the hood lock nut cap.


ii.
B450724C01
1.74,1.563 2.031,1.844 true 2.083,1.865 2.313,2.083 0.229,0.219 10 true *a
*a Hood Lock Bolt


Loosen the 2 bolts and hood lock bolt.


iii.

Adjust the hood lock assembly and tighten the 2 bolts and hood lock bolt.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


iv.

Check that the striker can engage the hood lock assembly smoothly.


v.
B450725

Install a new hood lock nut cap.



Hide 4.INSTALL FRONT BUMPER ASSEMBLY