Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY (for LED Headlight) › 2016.10–2019.09
RM32H0E _59 Vehicle Exterior _060313 LIGHTING (EXT) _0295714 HEADLIGHT ASSEMBLY(for LED Headlight) A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY(for LED Headlight)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the headlight assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Headlight ECU sub-assembly LH
·

Synchronize vehicle information

·

Initialize headlight ECU sub-assembly LH


Automatic headlight beam level control system (Click here)

NOTICE:

If the headlight assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.


HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 85319A 2.SEPARATE INLET HOSE (for RH Side)

E436576

a.

Remove the clip to separate the inlet hose.


Hide 3.REMOVE HEADLIGHT ASSEMBLY

a.
E351115C02
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the headlight assembly as shown in the illustration.


b.
E351117C01
0.583,3.021 0.656,2.75 true 2.302,3.052 2.396,2.813 true 0.438,3.063 0.646,3.26 0.208,0.198 10 true *a 2.167,3.094 2.385,3.292 0.219,0.198 10 true *a
*a Connector Lock Lever
V113147

Remove in this Direction


Disengage the claw, pull down the connector lock lever as shown in the illustration to disconnect the connector.


c.
E351118

Remove the bolt and 3 screws.


d.
E351119C02
0,0 0,0 false
V113147

Remove in this Direction


Remove the headlight assembly as shown in the illustration.